FIRESIGNAL by 1338

Live map › San Ciro-Ulmi-Filci (IT)

Active wildfire near San Ciro-Ulmi-Filci (IT) · 572 ha - since August 23, 2026

Active - last updated 15:10 UTC

Heat zone572 ha
Detections26
Max. radiative power113.0 MW
Duration18 hours

Satellites are currently recording a wildfire near San Ciro-Ulmi-Filci (IT). First detected 23-08-2026 20:54 (UTC), last seen 24-08-2026 15:10. The measured heat zone covered roughly 572 ha (an upper bound based on pixel size, not an official fire perimeter). The event counted 26 satellite detections (N21, S3B, SNPP, N20, MTG).

Active wildfire near San Ciro-Ulmi-Filci (IT) · 572 ha - since August 23, 2026
(c) OpenStreetMap (c) CARTO

View on the live map →

Key figures

First detection23-08-2026 20:54 UTC
Last detection24-08-2026 15:10 UTC
Coordinates37.8583, 12.7655

Course

Detections per period since the first observation. Each bar is a six-hour window; higher means more satellite pixels measured fire in that window. Most activity fell around 24-08 12:00 UTC.

Surroundings

Nearest town: San Ciro-Ulmi-Filci (IT), about 3 km. Larger town nearby: Palermo, about 60 km.

Observed by

This fire was seen by 5 satellite source(s): N21, S3B, SNPP, N20, MTG. Polar satellites deliver sharp measurements but pass over a few times a day; geostationary satellites watch continuously with a coarser pixel.

How these figures are produced

FireSignal groups individual satellite detections into a single fire event. The heat zone is the sum of the measured pixels and is therefore an upper bound: it says where heat was observed, not how many hectares actually burned. Official figures from fire services or authorities are usually lower. Cloud and thick smoke block the view, so there is always a gap between two observations.